噴泉泵電機繞組燒壞故障的原因及處理噴泉泵燒壞或者繞組緣損壞會是漏電，非常危險，在通電的情況下切勿用手去觸摸噴泉泵及管道等，以防觸電，應立即切斷電源，再處理。1、噴泉泵脫水運轉，冷卻惡化，應增加增加水位或者噴泉泵安裝位置降低。2、電源電壓過低，應調節變壓器電壓。3、噴泉泵電機繞組匝間，相間或對地短路，應該大修，更換繞組。4、電力電纜壓降過大，應該更換大一規格的電纜線。5、噴泉泵起動過於頻繁，應該按照說明書要求操作。6、水泵葉輪卡住，應該及時檢查葉輪，清楚葉輪雜物。7、噴泉泵進口堵塞，應及時清理入口雜物及加過濾網。

The cause and treatment of motor winding burnout of fountain pump and its insulation damage are leakage and very dangerous. Do not touch the fountain pump and pipeline with your hands in case of electrification, in order to prevent electric shock, the power supply should be cut off immediately and dealt with again. 1. Fountain pump dehydration operation, cooling deterioration, should increase water level or reduce the installation position of fountain pump. 2. If the voltage of power supply is too low, the voltage of transformer should be adjusted. 3. The windings of motor of fountain pump should be overhauled and replaced if they are short-circuit to ground or turn to turn. 4. If the voltage drop of power cable is too large, it is necessary to replace the larger size cable. 5. Fountain pumps start too frequently and should be operated according to the instructions. 6. When the impeller of the pump is stuck, the impeller should be inspected in time and the impurities of the impeller should be clear. 7. Blockage of fountain pump inlet should be promptly cleaned up and filtered.